Penerbit: Faculty of Engineering University of Lampung
P-ISSN: -
E-ISSN: 2549-3442
DOI: 10.23960/elc
Fakultas Teknik Teknik (semua kategori) Arsitektur
Artikel (543)
IDENTIFIKASI PLAT NOMOR KENDARAAN SECARA OFF-LINE BERBASIS PENGOLAHAN CITRA DAN JARINGAN SYARAF TIRUAN
Vehicle number plate identification and recognition systems used in many applications, such as parking lot access, traffic control, and vehicles monitoring and security. In this research, an offline system to read and identify vehicle number plate is developed. Vehicle number plate identification pr...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 6 No. 2 (2012); 123-126 | 2012
DESIGN MODEL OF AUTOMATION WASHER FOR TWO TUBES APERTURE (TWIN TUBE TOP LOADER) MICROCONTROLLER BASED ATMEGA32
Usually when doing household chores often accompany mothers with other occupations. Like when washing coupled with cooking or ironing. As a result of work performed at the same time, there is one job that is interspersed experiencing problems, eg when interrupted to cook, dishes to be burnt, or when...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 6 No. 2 (2012); 112-122 | 2012
Harmonics Assesment at Demand Site Through a 220V Wall Outlet
In recent year, non-linear loads, such as televisions, micro-computers and robotic equipments are increasingly connected to the system. These non-linear load inject a large amount of harmonics, especially third, fifth and seventh.Formerly, people just paid attention to the harmonics problem in the h...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 6 No. 2 (2012); 107-111 | 2012
Petunjuk Penulisan
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 3 No. 2 (2009) | 2012
Susunan Pengurus
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 3 No. 2 (2009) | 2012
Daftar Isi
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 3 No. 2 (2009) | 2012
Halaman Sampul
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 3 No. 2 (2009) | 2012
Analisis Peluahan Sebagian (Partial Discharge) Pada Transformator Step-Up Tegangan Rendah Dengan Proses Pengisolasian Yang Bervariasi
The existence of cavities (voids) in a solid insulating material will cause partial discharge when the insulation burdened by voltage. Cavity in the material usually results from defects at the time of production. The process of insulation at the time of production becomes very important to consider...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 3 No. 2 (2009); 135-146 | 2012
Rekonstruksi Citra Tomografi Kapasitansi Elektrik Menggunakan Metode Proyeksi Balik Linear Iteratif
The aim of this research is to observe the quality of images resulting from electrical capacitance tomography using iterative linear back projection. Tests have been conducted using a rod and straw(s) that put inside an 8 electrode capacitive sensor with various positions. Dispite the size of the re...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 3 No. 2 (2009); 125-134 | 2012
Prototipe Turbin Angin Skala Kecil Tipe Vertikal Axis Untuk Battery Charging Di Daerah Remote Area
Wind energy is an alternative source of renewable energy that can be converted to electricity by wind turbines. This paper presents a prototype small wind turbine stand alone mode. The prototype has vertical axis rotor with airfoil blades and applied to low wind speed 2.5 metre per second. Design of...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 3 No. 2 (2009); 119-124 | 2012