Penerbit: Faculty of Engineering University of Lampung
P-ISSN: -
E-ISSN: 2549-3442
DOI: 10.23960/elc
Fakultas Teknik Teknik (semua kategori) Arsitektur
Artikel (543)
Perancangan Simple Network Management Protocol (SNMP) Agent Simulator Berbasis Open Source Pada Jaringan World Wide InteroperabilityFor Microwave Access (WiMAX)
Network Management System (NMS) is one of network technologies which is required by Interoperability for Microwave Access (WiMAX) for monitoring, maintaining and managing. In managing the network, information transfer process that is occurred can be implemented by Simple Network Management Proto...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 3 (2008); 133-143 | 2012
Rancang Bangun Sistem Akuisisi Data Multifungsi Berbasis PC Menggunakan Mikrokontroller ATMega8535
A data acquisition is a method to collect information about a system. Instruments that can be considered as data acquisitions include oscilloscope, spectrum analyzer, and data logger. Although the instruments have different functions, they have the same building blocks. It will be practical if t...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 2 (2008); 69-78 | 2012
Desain Dan Implementasi Wireless LAN Berdasarkan Perhitungan Link Budget Dan Throughput (Studi Kasus BBS UnilaNet Tiga Satu Mandiri Prima)
Wireless LAN (Local Area Network) or WLAN is an information technology (IT) which use radio frequency or infrared (IR) as a transmission media. WLAN technologies have a wide coverage area and large capacity. WLAN Implementation must follow the rule of design; one of this is link budget calculation. ...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 2 (2008); 79-86 | 2012
Analisis Kontingensi Terhadap Probabilitas Blackout Pada Jaringan Sistem Tenaga Menggunakan Model Bertingkat
Electrical power system network is a very complex network which consist several component that interact between one and another. When one component operate exceed its limitation then protection system will react and that component will be cut off from the system. Component could also be cut off from...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 2 (2008); 87-94 | 2012
Respons Impuls Pada Elektroda Pentanahan Batang Tunggal Untuk Menentukan Nilai Impedansi Pentanahan
A good grounding system belived if the its resistance has a small value that measured with DC source or low frquency. Meanwhile, lightning stroke that caused impulse current with high frequency up to kHz, so when gounding system work when striking by lightning, its impedance not only mark out by res...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 2 (2008); 95-104 | 2012
Pemilihan Kapasitas Dan Lokasi Optimal Kapasitor Paralel Pada Sistem Distribusi Daya Listrik
Parallel capacitor have been many used for reactive power compensation in electric power distribution system. Parallel capacitor placement with no appropriate size and location often cause bus voltage excess their limit and also increase power losses. Therefore, the operation cost becomes bigger...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 2 (2008); 105-114 | 2012
Pengendalian Kecepatan Motor Arus Searah Dengan Logika Fuzi
The system which implements Fuzzy Logic Controller (FLC) on AT89C52 for controlling the speed of DC motor is not only able to stabilize the motor speed according to desired setpoint but also stabilize it on variable loads. The speed control is performed by regulating field voltage Vf with regulator ...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 2 (2008); 115-120 | 2012
Pola Peluahan Parsial (Partial Discharge-PD) Pada Bahan Isolasi Epoxy Resin
High voltage insulation failure that led to the breakdown of events is crucial reliability of a power system Most of the failure of the insulation caused by the presence of PD activity on the insulation material, especially the solid insulation which triggering the growing of electrics tree. To ...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 2 (2008); 121-132 | 2012
Perancangan dan Simulasi Sistem Kompresi Suara dengan Transformasi DCT
This paper discuss design of sound compression system using VHDL syntax, XACT tools step 6.0, Xilinx Inc. and Proseries View Logic System. This process covered entry design, simulation by functionally or static clock. The compression system using the maximum clock frequency 2,8 MHz. The simula...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 1 (2008); 55-67 | 2012
Analisis Karakteristik Gangguan Hubung Singkat Antar Belitan Transformator Menggunakan Transformasi Wavelet Diskrit
Transient fault could occur on transformer in power system. This is could be because of internal fault or external fault. Disturbance could be because of short circuit between winding of transformer or because of short circuit on load. Short circuit on transformer winding could lead to catastrophic ...
Electrician : Jurnal Rekayasa dan Teknologi Elektro; Vol. 2 No. 1 (2008); 48-54 | 2012